2

I have a fresh 18.10 install (not an upgrade) which ran fine for days now when I suspend then resume it has logged me out ... This behavior is repeatable ... every suspend results in a resume into a fresh login session. My uptime indicates its not a reboot just a log out

Does not appear to be a dupe of Ubuntu 18.04 error on waking up from sleep : Read-error on swap device

here is my dmesg

[26608.984186] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26609.000454] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26609.021691] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26611.124524] wlp2s0: authenticate with 00:23:69:9e:ae:7f
[26611.131872] wlp2s0: send auth to 00:23:69:9e:ae:7f (try 1/3)
[26611.138863] wlp2s0: authenticated
[26611.139067] iwlwifi 0000:02:00.0 wlp2s0: disabling HT as WMM/QoS is not supported by the AP
[26611.139069] iwlwifi 0000:02:00.0 wlp2s0: disabling VHT as WMM/QoS is not supported by the AP
[26611.146696] wlp2s0: associate with 00:23:69:9e:ae:7f (try 1/3)
[26611.149328] wlp2s0: RX AssocResp from 00:23:69:9e:ae:7f (capab=0x411 status=0 aid=2)
[26611.152190] wlp2s0: associated
[26611.180321] IPv6: ADDRCONF(NETDEV_CHANGE): wlp2s0: link becomes ready
[26621.901198] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26621.916075] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26621.935734] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[26623.176050] rfkill: input handler disabled
[27152.084848] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29289.263525] wlp2s0: deauthenticating from 00:23:69:9e:ae:7f by local choice (Reason: 3=DEAUTH_LEAVING)
[29289.321673] PM: suspend entry (deep)
[29289.321675] PM: Syncing filesystems ... done.
[29298.783766] rfkill: input handler enabled
[29299.075220] Freezing user space processes ... (elapsed 0.005 seconds) done.
[29299.081055] OOM killer disabled.
[29299.081056] Freezing remaining freezable tasks ... (elapsed 0.002 seconds) done.
[29299.083226] Suspending console(s) (use no_console_suspend to debug)
[29299.103284] sd 2:0:0:0: [sda] Synchronizing SCSI cache
[29299.161935] sd 2:0:0:0: [sda] Stopping disk
[29300.169199] ACPI: EC: interrupt blocked
[29300.221949] ACPI: Preparing to enter system sleep state S3
[29300.226223] ACPI: EC: event blocked
[29300.226224] ACPI: EC: EC stopped
[29300.226226] PM: Saving platform NVS memory
[29300.226348] Disabling non-boot CPUs ...
[29300.239384] IRQ 132: no longer affine to CPU1
[29300.240400] smpboot: CPU 1 is now offline
[29300.263319] IRQ 129: no longer affine to CPU2
[29300.264341] smpboot: CPU 2 is now offline
[29300.295256] IRQ 122: no longer affine to CPU3
[29300.295271] IRQ 130: no longer affine to CPU3
[29300.296301] smpboot: CPU 3 is now offline
[29300.303275] ACPI: Low-level resume complete
[29300.303354] ACPI: EC: EC started
[29300.303355] PM: Restoring platform NVS memory
[29300.305660] Enabling non-boot CPUs ...
[29300.305708] x86: Booting SMP configuration:
[29300.305708] smpboot: Booting Node 0 Processor 1 APIC 0x2
[29300.306214]  cache: parent cpu1 should not be sleeping
[29300.306334] microcode: sig=0x806e9, pf=0x80, revision=0x38
[29300.307835] CPU1 is up
[29300.307892] smpboot: Booting Node 0 Processor 2 APIC 0x1
[29300.308411]  cache: parent cpu2 should not be sleeping
[29300.308502] microcode: sig=0x806e9, pf=0x80, revision=0x8e
[29300.308606] CPU2 is up
[29300.308633] smpboot: Booting Node 0 Processor 3 APIC 0x3
[29300.309114]  cache: parent cpu3 should not be sleeping
[29300.309317] CPU3 is up
[29300.313109] ACPI: Waking up from system sleep state S3
[29300.323688] ACPI: EC: interrupt unblocked
[29300.366900] ACPI: EC: event unblocked
[29300.370092] sd 2:0:0:0: [sda] Starting disk
[29300.662986] usb 1-5: reset high-speed USB device number 5 using xhci_hcd
[29300.939113] usb 1-8: reset full-speed USB device number 7 using xhci_hcd
[29301.214978] usb 1-7: reset full-speed USB device number 6 using xhci_hcd
[29302.084494] ish-hid {33AECD58-B679-4E54-9BD9-A04D34F0C226}: [hid-ish]: enum_devices_done OK, num_hid_devices=2
[29302.203528] usb 1-1: reset low-speed USB device number 2 using xhci_hcd
[29302.548544] acpi LNXPOWER:13: Turning OFF
[29302.548785] acpi LNXPOWER:12: Turning OFF
[29302.549013] acpi LNXPOWER:11: Turning OFF
[29302.549243] acpi LNXPOWER:10: Turning OFF
[29302.549469] acpi LNXPOWER:0f: Turning OFF
[29302.549694] acpi LNXPOWER:0e: Turning OFF
[29302.549919] acpi LNXPOWER:0d: Turning OFF
[29302.550146] acpi LNXPOWER:0c: Turning OFF
[29302.550372] acpi LNXPOWER:0b: Turning OFF
[29302.550595] acpi LNXPOWER:0a: Turning OFF
[29302.550859] acpi LNXPOWER:09: Turning OFF
[29302.551082] acpi LNXPOWER:08: Turning OFF
[29302.551304] acpi LNXPOWER:07: Turning OFF
[29302.551526] acpi LNXPOWER:06: Turning OFF
[29302.551756] acpi LNXPOWER:04: Turning OFF
[29302.551980] acpi LNXPOWER:03: Turning OFF
[29302.552203] acpi LNXPOWER:02: Turning OFF
[29302.552425] acpi LNXPOWER:01: Turning OFF
[29302.552647] acpi LNXPOWER:00: Turning OFF
[29302.552789] OOM killer enabled.
[29302.552791] Restarting tasks ... done.
[29302.559631] Bluetooth: hci0: Bootloader revision 0.0 build 2 week 52 2014
[29302.564120] thermal thermal_zone4: failed to read out thermal zone (-61)
[29302.571287] Bluetooth: hci0: Device revision is 5
[29302.571289] Bluetooth: hci0: Secure boot is enabled
[29302.571292] Bluetooth: hci0: OTP lock is enabled
[29302.571293] Bluetooth: hci0: API lock is enabled
[29302.571294] Bluetooth: hci0: Debug lock is disabled
[29302.571295] Bluetooth: hci0: Minimum firmware build 1 week 10 2014
[29302.571299] Bluetooth: hci0: Found device firmware: intel/ibt-11-5.sfi
[29302.586626] PM: suspend exit
[29302.718694] ata3: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[29302.924178] rfkill: input handler disabled
[29303.137427] ata3.00: configured for UDMA/133
[29303.218213] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[29303.277237] Chrome_~dThread[31595]: segfault at 0 ip 00007faa0107614f sp 00007fa9f8a96ab0 error 6 in libxul.so[7fa9fd9e3000+4bac000]
[29303.277244] Code: 8b 0d 05 3d 62 03 48 89 01 c7 04 25 00 00 00 00 73 01 00 00 e8 52 66 97 fc 48 8d 05 06 b3 66 01 48 8b 0d e4 3c 62 03 48 89 01 <c7> 04 25 00 00 00 00 6d 0a 00 00 e8 31 66 97 fc 90 55 48 89 e5 41 
[29303.277713] Chrome_~dThread[31832]: segfault at 0 ip 00007fb8b0fda14f sp 00007fb8a89faab0 error 6 in libxul.so[7fb8ad947000+4bac000]
[29303.277717] Code: 8b 0d 05 3d 62 03 48 89 01 c7 04 25 00 00 00 00 73 01 00 00 e8 52 66 97 fc 48 8d 05 06 b3 66 01 48 8b 0d e4 3c 62 03 48 89 01 <c7> 04 25 00 00 00 00 6d 0a 00 00 e8 31 66 97 fc 90 55 48 89 e5 41 
[29303.279621] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29303.305878] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29303.320049] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29303.494372] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[29303.559297] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready
[29303.623129] rfkill: input handler enabled
[29304.057065] Bluetooth: hci0: Waiting for firmware download to complete
[29304.057601] Bluetooth: hci0: Firmware loaded in 1466071 usecs
[29304.057611] Bluetooth: hci0: Waiting for device to boot
[29304.069678] Bluetooth: hci0: Device booted in 11789 usecs
[29304.069682] Bluetooth: hci0: Found Intel DDC parameters: intel/ibt-11-5.ddc
[29304.073659] Bluetooth: hci0: Applying Intel DDC parameters completed
[29304.508742] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29304.536533] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29304.555933] usb 1-3: current rate 4500480 is different from the runtime rate 44100
[29306.976415] wlp2s0: authenticate with 00:23:69:9e:ae:7f
[29306.984290] wlp2s0: send auth to 00:23:69:9e:ae:7f (try 1/3)
[29306.992232] wlp2s0: authenticated
[29306.992490] iwlwifi 0000:02:00.0 wlp2s0: disabling HT as WMM/QoS is not supported by the AP
[29306.992491] iwlwifi 0000:02:00.0 wlp2s0: disabling VHT as WMM/QoS is not supported by the AP
[29306.994584] wlp2s0: associate with 00:23:69:9e:ae:7f (try 1/3)
[29306.997426] wlp2s0: RX AssocResp from 00:23:69:9e:ae:7f (capab=0x411 status=0 aid=2)
[29306.999970] wlp2s0: associated
[29307.023276] IPv6: ADDRCONF(NETDEV_CHANGE): wlp2s0: link becomes ready
[29318.243823] rfkill: input handler disabled

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.