0
votes
0answers
72 views

Network bridging and routing

i have a isp. and i have ubuntu server 12.4 with three nic. here eth0 ip is 10.10.10.15 with the gateway 10.10.10.1, eth1 ip is 10.0.0.20 with the gateway 10.0.0.1 and last eth2 my local lan ip ...
0
votes
0answers
67 views

configuring containers to use Veth#, bridges and vlans on the server (only)?

I have two groups of lxc contianers on a server and want to isolate their network traffic for security reasons. I will be using port forwarding so the containers much each have separate IP's. I know ...
0
votes
0answers
280 views

Change bridged network interface created by KVM install

I have recently installed Ubuntu 12.04 LTS server and I chose to install Virtual Machine Host as one of the packages during install. The server has an on-board NIC and a PCI NIC and during install, ...
2
votes
1answer
2k views

Bonding + Bridge : traffic passing through the wrong interface

I'm using Ubuntu server 12.04, on a server with 6 NICs, grouped in 2 bundles : eth0 and eth2 are bundled using bonding mode 1, under interface name bond0 which has IP [network].8 eth1, eth3, eth4 ...
1
vote
0answers
147 views

bridge a connection and keep same ip and subnet

I have googled this for a while now but am not able to find answer to this question. I have my xbox bridged to my ubuntu pc. Everything works, maybe just gives an nat error now and then. I want to be ...
9
votes
3answers
21k views

KVM Bridged Network Not Working

I just installed KVM on my Ubuntu Server according to this guide : https://help.ubuntu.com/community/KVM/Installation Then prepared a bridged network as shown in here : ...
2
votes
1answer
1k views

Can't get bonding and bridging to work for KVM [closed]

I can't for the life of me get bonding and bridging to work for the KVM setup I'm building. I'm using a fresh install (not an upgrade) of Ubuntu Server 10.10. I have 4 NICs on the same subnet (two ...