0
votes
0answers
27 views

PulseAudio + HFP profile in Ubuntu

Objective is to attend the call via BT paired devices using HFP Steps done: a. The softwares used are -pulseaudio-4.99.2 -Bluez-5.14 -ofono-1.14 b. The above mentioned application were started ...
1
vote
1answer
98 views

bluetooth headset connects but not showing in sound settings

I was able to listen with my BT headset, but suddenly, one day, it disappeared from sound settings forever! I've even re-paired my headset (and its connected already) but it doesn't have any options ...
2
votes
1answer
35 views

How to change the volume of left channel using pulseaudio

I am recording the video using logitech camera and bluetooth microphone. Logitech can used for recording both audio and video. When I turn on bluetooth microphone in the middle of recording, it is ...
1
vote
0answers
190 views

JBL bluetooth speakers play no sound, a2dp off?

I have JBL bluetooth speakers like this one. With Ubuntu 14.04 LTS (Gnome) I get it to pair with my pc, either with gnome-bluez or blueman, but I am unable to reproduce any sound. I stumbled upon ...
0
votes
0answers
136 views

Bluetooth Headphones works poorly (14.04)

Recently I bought a Philips SHB9100 Bluetooth Headphones. I first tried to connect them using the default Ubuntu Bluetooth device manager but the headphones were not shown in the Audio Settings. Then, ...
0
votes
0answers
48 views

A2DP on PulseAudio - terrible choppy/skipping audio

I have paired my Bluetooth headset with my Ubuntu 12.04 laptop with a Bluetooth chip inside: lsusb | grep Bluetooth Bus 003 Device 003: ID 045e:0745 Microsoft Corp. Nano Transceiver v1.0 for ...
0
votes
1answer
116 views

PulseAudio unable to detect Bluetooth Headset

I am able to successfully pair with my bluetooth headset (Motorola S305), and connect to Audio Sink. However, it does not show up in PulseAudio (in any way I ask it), and I can't switch the audio ...
0
votes
0answers
26 views

Is it possible to stream audio via Bluetooth from Ubuntu to Ubuntu/Debian?

I resuscitated an 14 years old pc with a very good audio set and made a stereo of it. Via Bluez+Pulse I can stream music from my Android phone to this PC easily. My Ubuntu laptop is paired and ...
0
votes
0answers
25 views

PulseAudio automatically loads default loopback module after I load one

I am trying to stream audio from a Bluetooth source to a Bluetooth sink. I connect the devices, get confirmation that their modules are loaded in PulseAudio, then I load the loopback module. The ...
0
votes
0answers
15 views

automatically switch to newly-connected devices

I am using pulseaudio, I want to switch the logitech mic and bluetooth devices to each other when one of these are connected. I am getting the command for that: load-module module-switch-on-connect ...
1
vote
0answers
42 views

PulseAudio channel map at run time

Could I map (Swap) the channel at run time. I am using the ffmpeg to record the both video and audio from two logitech cam/mic and bluetooth mic. Now currently at the starting of recording bluetooth ...
0
votes
1answer
293 views

Bluetooth high quality support gone in ubuntu 14.04?

I have a bluetooth speaker (http://www.sound2go.net/produkte/bigbass-plus). In ubuntu 13.10 I could go to the audio settings and choose the bluetooth mode (Telephony - Low Quality, of High Quality). ...
0
votes
0answers
62 views

How can I set my Bluetooth-speakers “default” volume lower than 100%?

I finaly got my Jabra Solemate playing nice with my desktop computer. However, every time I connect my Solemate, the volume setting in PulseAudio pops (back) up to 100%. What I'd like, is for it to ...
0
votes
2answers
361 views

Sony Ericsson SBH50 Bluetooth headset not working on 13.10 [closed]

I recently upgraded my bluetooth headset from a MW600 to a SBH50. The MW600 worked fine, but I cannot get the SBH50 working. I can pair with the device, and it shows up in my sound settings, but when ...
0
votes
1answer
175 views

Bluetooth: Pairing two ubuntu 13.10 machines for audio streaming fails

I'm trying to stream audio over bluetooth from my laptop to my nas. Both run ubuntu 13.10. I have so far successfully streamed music form three different android phones to the nas. The nas pair's ...
1
vote
1answer
710 views

Successfully connected to a bluetooth speaker, but how do i direct sound there?

I'm running Kubuntu 13.10 on a Lenovo Thinkpad T430 laptop. I've got a Bluetooth speaker. After a lot of troubleshooting i managed to connect to the speaker. bt-device reports: $ bt-device -l Added ...
0
votes
0answers
127 views

No audio devices after connecting bluetooth speaker

When I connect my bluetooth speaker to my pc sometimes the connection goes wrong. I hear the beeb on my speaker telling me it's connected but when i try to play audio nothing happens. When I look in ...
0
votes
1answer
25 views

Can't find Bluetooth file

This may sound dumb, but i have searched everywhere for /etc/bluetooth/audio.conf . I cannot find it. I have tried searching and doing everything of the manner, but I cannot find it. Please help.
3
votes
2answers
3k views

Bluetooth device paired and connected (no sound)

I've got a Bluetooth headset which works great in both Windows 8 and Android 4.2 however on Ubuntu (13.10) it just doesn't seem to work. I installed Blueman, it paired and connected successfully when ...
1
vote
0answers
75 views

Not working PulseAudio = no audio?

I have one question. For my thesis I need to install last version of BlueZ, since I need to work with Bluetooth Low Energy and I found that main reason why BlueZ 5.x is not in Ubuntu is current ...
3
votes
2answers
1k views

13.04 Logitech bluetooth speaker adapter pairing but no mixer output

I had to change [General] Enable = Socket in /etc/bluetooth/audio.conf to get it to pair. But now that they are I don't get an output in pavucontrol. D: [pulseaudio] bluetooth-util.c: Registering ...
2
votes
1answer
1k views

Bluetooth refuses to connect since update to Ubuntu Gnome 13.10

I can no longer connect to my bluetooth speakers since since upgrading to Ubuntu Gnome 13.10 and then Gnome shell to 3.10, which never were a problem with Ubuntu Gnome 13.04. My bluetooth-dongle ...
3
votes
2answers
6k views

Pulseaudio not detecting bluetooth headset automatically

The Pavucontrol on my Xubuntu 13.10 detects my bluetooth headset, but only after I type the commands : pulseaudio -k sudo alsa force-reload After a few seconds the headset appears in the ...
0
votes
0answers
1k views

Automatically connect headless server running pulseaudio and mpd to bluetooth sound system (Ubuntu 13.10)

I have a headless server that stores, among other things, my music collection. It runs mpd. Next to the server, I have a sound system (Sony BDV N7100) which can play back music connected to it via ...
1
vote
0answers
92 views

BRAVEN 600 bluetooth speaker doesn't play back audio 13.04

I'm having issues with getting audio to actually play through my Bluetooth speaker. It will connect fine, and in Bluetooth settings, it will say that it is paired. However, no matter how many times I ...
0
votes
0answers
132 views

How to add delay to one audio card to sync simultaneous output?

Through PulseAudioPreferences (paprefs) I can use both my sound card and Bluetooth (A2DP) speaker simultaneously, (I want to play the same music in the yard and inside the house). The problem is that ...
4
votes
1answer
4k views

“Connection failed: Stream setup failed” when using A2DP [closed]

I'm trying to use my PC as a A2DP sink for my Nexus 7, but I can't seem to connect. The bluetooth dongle I'm using is the ASUS-BT211 Things that I have tried already: Adding Source to the ...
0
votes
0answers
403 views

13.04 bluetooth speakers pair/connect but don't play

Under 13.04 I can pair and connect to my bluetooth speakers without difficulty. But I can't get sound out of them. If I go into Sound Settings and select the bluetooth speakers there, when I run ...
2
votes
1answer
1k views

Trying to remove Bluetooth, safe to do?

I am running Ubuntu 12.04 LTS on a computer that has 0 Bluetooth support, I wish to remove the options for it so my users don't get confused or frustrated thinking the computer DOES have Bluetooth ...
0
votes
2answers
2k views

Setting up a bluetooth audio-microphone headset on ubuntu 12.04

I recently purchased a Henson BTH033 bluetooth headset with a built in microphone. I would ideally like to use it as my primary audio-microphone output-input on my ubuntu install. Here is my ...
3
votes
0answers
4k views

play audio through bluetooth speakers in 12.04 using CLI

I have gone through the whole gamut of trials with setting up playing audio through bluetooth and have not been able to make it work reliably (i.e., got it to work one time, and has not worked after ...
7
votes
5answers
12k views

Ubuntu 13.04 bluetooth A2DP does not work

I have installed Ubuntu 13.04 in a new partition and I have some issues with bluetooth. I usually use bluetooth to connect to my wireless headset, in the old partition with Ubuntu 12.10 everything is ...
1
vote
1answer
746 views

Rhythmbox play no sound after changing output device

Problem: Rhythmbox play no sound after changing output device. Ubuntu 12.04, i386, Rhythmbox 2.96. How i get this: - I have connected to my laptop a bluetooth headset. - In sound preferences I ...
2
votes
1answer
304 views

Autoconnecting to bluetooth device on startup and autochanging audio output

I use ubuntu 12.10 64 bit. Every time I turn my computer on, I have to manually connect to my bluetooth speakers and change audio output to bluetooth device. I've found this question: Autoconnecting ...
1
vote
0answers
240 views

Output audio from multiple bluetooth sources simultaneously

I recently discovered the bluetooth capabilities in Ubuntu. Would it be possible to configure my HTPC(Ubuntu 12.10) so it would allow pairing multiple bluetooth audio devices(iPhone and 2 Windows PCs) ...
3
votes
1answer
5k views

Pulse Audio Bluetooth card profile not displaying on Ubuntu 12.10

I am running Ubuntu 12.10 and don't see a bluez_card profile on my system: $ pactl list cards short 0 alsa_card.pci-0000_00_1b.0 module-alsa-card.c I tried to load the module as suggested ...
0
votes
1answer
1k views

bluetooth headset can connect, but not visible in pulse audio

I have a plantronics bluetooth headset, and until yesterday I could use it without any problem. However, today it suddenly stopped working (maybe related to the last software update I did). I can ...
2
votes
2answers
2k views

Android device connects to my computer, but doesn't play audio over Bluetooth

I turn on Bluetooth on both my devices and open up Music on my Android. I select a song to play, press the menu button, and tap "Via Bluetooth": I tap on my computer in the "Bluetooth Device ...
3
votes
1answer
1k views

Accidentally changed Bluetooth mode to off

My Bluetooth device disappeared after I changed its mode from High Fidelity A2DP to off. Is this a bug? How can I get my speaker back into the audio menu? I tried disconnecting and reconnecting. But ...
7
votes
3answers
572 views

How to redirect single audio channels to different devices?

I just bought a bluetooth stereo speaker and I had an idea: Is it possible to build a 4.0 audio system using my Bluetooth speakers as rear speaker and two normal cabled stereo speakers (or another ...
3
votes
2answers
2k views

Switch between speaker, Bluetooth stereo, Bluetooth mono

Using a bluetooth headset that does Stereo (out only), mono (in / out) and speakers. Switching between the 3 is a lot of clicks. What I want to do: - run Stereo either on Speaker or headset - when I ...
14
votes
5answers
33k views

Get rid of 0.5s latency when playing audio over Bluetooth with A2DP

As described in the title I experience a half a second delay when playing audio over Bluetooth with A2DP. This makes watching movies not possible as the sound is not synchronised with the video. I'm ...
3
votes
4answers
9k views

A2DP connection not shown in PulseAudio

I'm trying to pipe the audio ouput to my Belkin Z73 bluetooth receiver but once connected and paired with the key 0000 the receiver doesn't show up in PulseAudio. Furthermore the following command ...
2
votes
1answer
391 views

Controlling multiple audio outputs volume?

I have a little Bluetooth audio receiver, which I use to play music through my stereo. Every time I power it on, all audio automatically switchs to it, but ALSA seems not to "know" it, so volume keys ...
3
votes
2answers
923 views

Does Ubuntu support Bluetooth 3.0?

I am running 11.10 on my Thinkpad E420, and it has integrated Bluetooth 3.0, yet when I use my Plantronics Backbeat 903+ (which uses Bluetooth 2.1) I get terribly inconsistent audio with many complete ...
0
votes
1answer
519 views

How to troubleshoot Bluetooth connection with headset?

How can I troubleshoot or debug my Bluetooth headset connection in 11.10? I am able to successfully create a working connection to my Bluetooth headset. I am able to route the input and output to the ...
6
votes
4answers
4k views

Can I use my Bluetooth headset as a microphone?

I have a Motorola S305 Bluetooth headset which I use with my computer often for headphones. I've been using them for a while and have been really pleased with the sound quality, form factor, and ...
1
vote
2answers
760 views

Bluetooth audio stops working after some random time [closed]

I am using Ubuntu 11.04 and want to use my new Nokia BH-503 Bluetooth headsets with Ubuntu to watch movies and listen songs. I can pair my headsets using a Bluetooth dongle, and even see it in sound ...
7
votes
3answers
2k views

Stream audio to mobile device

I'd like to stream the audio from Ubuntu 10.10 to my HTC Desire HD (Android 2.2). I've seen solutions so far for streaming from audio players, but I'd like to stream any audio output from the PC to ...
5
votes
1answer
579 views

How can I determine what codec is being used? [closed]

This forum comment and this superuser answer suggest that the audio compression contributes to loss of quality. I've noticed that music played over my BT setup sometimes pitch bends in ways I don't ...