Take the 2-minute tour ×
Ask Ubuntu is a question and answer site for Ubuntu users and developers. It's 100% free, no registration required.

I've installed Mythbuntu and during the install I selected my hauppauge tv card and the remote doesn't work. Now what do I do?

I see a .lircrc file in my home dir but ps -ef|grep lirc yields nothing. I've read on other posts that the kernel is now handling this but I don't know what to try. irw isn't installed.

How does a program get signals from the remote without lirc installed? Where are the config files I need to look at? How can I debug this?

share|improve this question
    
Which model of TV card is it? Most of the newer ones implement the remote input as an input device (like an extra keyboard). My setup (which is quite old now) takes a hybrid approach - I use the raw key impulses the remote generates by default, and also run lircd in "evdev" mode (which uses input devices instead of IR pulses) to route commands to programs like mplayer. Step 1 : does pushing the "OK" button on the remote cause an "enter" impulse in the current terminal? –  Adrian Jan 23 '12 at 12:55
    
No. Nothing happens no matter which keys I press on the remote. –  phyre Jan 24 '12 at 14:05
    
Try tail -f /var/log/kern.log and pushing all the buttons again to see what gets logged. –  Adrian Jan 24 '12 at 15:15

1 Answer 1

Personally, with my Nova-T usb tv stick and remote I install lirc, sudo apt-get install lirc and choose my usb tv stick and when choosing the remote it doesn't really show me it listed, so I just choose anything. I stop the lirc service, sudo service lirc stop and run cat /proc/bus/input/devices which gives me

I: Bus=0003 Vendor=2040 Product=7070 Version=0100
N: Name="IR-receiver inside an USB DVB receiver"
P: Phys=usb-0000:00:1d.0-1.1/ir0
S: Sysfs=/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.1/rc/rc0/input14
U: Uniq=
H: Handlers=kbd event14

I then edit /etc/lirc/hardware.conf and change REMOTE_DEVICE= to REMOTE_DEVICE="/dev/input/event14" to match my remotes event id, then restart lirc, sudo service lirc start

Hope this helps somewhat.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.