My boss asked me to install Ubuntu 12.04 LTS 32 bit on an old-ish laptop with an external US Robotics Wifi card and an internal ethernet card. I have gone through all the painful hops about installing the Wifi card driver, then suceeded getting wpa-supplicant to make it connect. Then I installed LUbuntu because I need to use Firefox on it. No Network manager or anything, as the graphic interface will only be invoked once a week and this laptop works as an "always on" database slave.
Now, I have several issues:
- I can only issue 1 ping before it completely stops communicating. That ping shall show 3 successful low latency replies then hangs till I CTRL-C it.
- Otherwise, I may succesfully open one (1) web page in Firefox and then it completely stops communicating.
- While I am at it: I need the Wlan to be the main interface. The internal ethernet interface gets only connected once a week. When it happens, it should be possible to telnet into it from other computers.
The first two issues seem related and also look like this previous question with the big difference I don't have Network Manager so I don't know where to look. That computer is terminal only with an afterwards attached thin graphic install. For the second issue, I don't know how to create the configuration to let it work. As of now both interfaces are unreachable from our LAN and I don't know if it's due to the first issues or not. In order to try debug the situation I have commented the built in ethernet adapter but I have not seen any benefit on the other. The wlan must be always on since boot and shall have a fixed IP address.
I am posting some of my (anonymized) configs below, if you are so kind to help me I'll post other configs as you feel fit to ask.
Thanks in advance.
/etc/hosts 127.0.0.1 localhost # 192.168.1.9 lxsrv01.domain.tld lxsrv01 dbserver 192.168.1.10 lxsrv01.domain.tld lxsrv01 dbserver # The following lines are desirable for IPv6 capable hosts ::1 ip6-localhost ip6-loopback fe00::0 ip6-localnet ff00::0 ip6-mcastprefix ff02::1 ip6-allnodes ff02::2 ip6-allrouters resolv.conf nameserver 18.104.22.168 nameserver 22.214.171.124 nameserver 126.96.36.199 search domain.tld Home root@lxsrv01:~# route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 wlan0 0.0.0.0 192.168.1.1 0.0.0.0 UG 100 0 0 wlan0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 wlan0 root@lxsrv01:~# ifconfig eth0 Link encap:Ethernet HWaddr 00:0e:a6:aa:5b:be inet addr:192.168.1.9 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:16 errors:0 dropped:0 overruns:0 frame:0 TX packets:16 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:1140 (1.1 KB) TX bytes:1140 (1.1 KB) wlan0 Link encap:Ethernet HWaddr 00:c0:49:fc:db:3f inet addr:192.168.1.10 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::2c0:49ff:fefc:db3f/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:14799 errors:0 dropped:0 overruns:0 frame:0 TX packets:4043 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:7354838 (7.3 MB) TX bytes:440079 (440.0 KB) root@lxsrv01:~# grep -i "wlan" /var/log/dmesg [ 14.360963] b43-phy0: Broadcom 4318 WLAN found (core revision 9) [ 17.601221] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 18.912230] wlan0: authenticate with 74:88:8b:84:e8:ad [ 18.912550] wlan0: send auth to 74:88:8b:84:e8:ad (try 1/3) [ 18.914068] wlan0: authenticated [ 18.916034] wlan0: associate with 74:88:8b:84:e8:ad (try 1/3) [ 18.920557] wlan0: RX AssocResp from 74:88:8b:84:e8:ad (capab=0x411 status=0 aid=3) [ 18.921071] wlan0: associated [ 18.921268] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready