Take the 2-minute tour ×
Ask Ubuntu is a question and answer site for Ubuntu users and developers. It's 100% free, no registration required.

I have spent the last 4 days or so trying to setup Ubuntu server 12.04.2 with RAID1. I have looked at several different links and tried different configurations and workarounds. So far, I have not come out with a successful installation that passes the final test -- pulling out one drive, booting and checking the contents of my home folder, and doing the same for the other drive.

So far, the closest I have come to succeeding is by setting up partitions this way:

/dev/sda1: allocated for RAID
/dev/sda2: swap area
/dev/sdb1: allocated for RAID
/dev/sdb2: swap area (or left unassigned -- which somehow gets allocated as a swap area later on anyway)
/dev/md0: (paired sda1 and sdb1) RAID1 device, ext4 filesystem, mount point /

This installs successfully, I boot the system, then create a file called "test" on my home folder.

I then shut down, disconnect drive b, power up, and check my home folder. "test" is there...so far so good. Then I create a second file, "test2."

I shut down, reconnect drive b, power up, and check the folder. Both files are there.

I shut down, disconnect drive a, power up and check the folder. Both files are ABSENT from drive b.

If anyone has any ideas on how I can successfully set this up and get my RAID1 working, I will be very grateful and happy.

Oh yes...I've tried setups with 3 partitions instead of 2, with EFI Boot and/or biosgrub, with no success (Either it would not boot, or I encounter the same situation with the test results above)

Thanks.

share|improve this question

1 Answer 1

up vote 2 down vote accepted

After more research, trial and error, and one phone call to a friend, I finally got this to work.

Apparently, there is something wrong with the Ubuntu Installer's partition manager -- so I had to use GParted (http://gparted.sourceforge.net/) to partition the disk BEFORE running the installer.

I setup 2 partitions with gparted (ext4 and swap), then ran the Ubuntu installer, set up raid, and everything went on smoothly.

When I ran the test (pulling out one drive), the test file I wrote still existed on the second drive and that proved my raid installation worked.

Just a note: when I plug the other drive back in, it does NOT automatically sync back. I have to re-add it to the raid array by:

sudo mdadm --add /dev/md0 /dev/sdb1

(replace md0 with the actual raid array name and sdb1 with the actual hard drive name)

A very helpful resource for this is the Mdadm Cheat Sheet (http://www.ducea.com/2009/03/08/mdadm-cheat-sheet/)

share|improve this answer
    
As I noticed, mdadm has problems with autocreating arrays, even if their definitions exist in /etc/mdadm/mdadm.conf. –  Danatela Jul 12 '13 at 4:29

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.