Take the 2-minute tour ×
Ask Ubuntu is a question and answer site for Ubuntu users and developers. It's 100% free, no registration required.

I have Dell 7520 with AMD Raedon 7XXXM graphics card, thankfully, I got to make it work. But the problem now is screen resolution, as I have screen resolution of 1920 X 1080 for 15.6" laptop, which is way too much. In the Display Monitor settings, I cannot change it to whatever I want, only the resolution with 16:9 works perfectly. I have options for other resolution setting but, selecting others brings the screen edges near, that means it leaves gap on both sides of screens. And to read contents from such high resolution is too small, as I need magnifying glass.

I have other suitable 16:9 resolution as 1360 X 768 but thats too big. I want something like 1600 X 1024 which would be good resolution for me. But when I change that via Display Monitor settings, again the edge becomes narrow.

I don't have the option of widening the layout from keyboard shortcuts too, if there is any way to fix this then it'd be very great...

share|improve this question

1 Answer 1

up vote 1 down vote accepted

You can add undetected resolutions.

Press Ctrl-Alt-t. In the terminal run

$ xrandr
Screen 0: minimum 320 x 200, current 1366 x 768, maximum 8192 x 8192
LVDS1 connected 1366x768+0+0 (normal left inverted right x axis y axis) 309mm x 174mm
    1366x768       60.0*+   50.0  
    1360x768       59.8     60.0  
    1024x768       60.0  
    800x600        60.3     56.2  
    640x480        59.9  
VGA1 disconnected (normal left inverted right x axis y axis)
HDMI1 disconnected (normal left inverted right x axis y axis)
DP1 disconnected (normal left inverted right x axis y axis)

Note LVDS1 in the output. That's the mode in this case; yours might be different. I'll refer to it as <mode>.

now create modeline for your resolution. You want 16:9 -> 1366x768 at 60Hz. Run

$ cvt 1366 768 60
# 1368x768 59.88 Hz (CVT) hsync: 47.79 kHz; pclk: 85.25 MHz
Modeline "1368x768_60.00"   85.25  1368 1440 1576 1784  768 771 781 798 -hsync +vsync

I'll refer to everything after the word "Modeline" as <modeline>

Now create the new mode with the modeline from the previous command. Run

$ xrandr --newmode <modeline>

Now add the mode (see xrandr command above). Run

$ xrandr --addmode <mode> 1366x768

Finally switch to it. Run

$ sudo xrandr --output <mode> --mode 1366x768
share|improve this answer
thanks for the detailed info... it works, but somewhat weird graphics... I'll try to fix it, if I can. –  Jhilke Dai Feb 22 '13 at 11:50

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.