I can ping all devices on the network except the gateway (192.168.0.1) and in turn can not access outside of the network without proxying through another device.
Lenovo x230 Tablet with a Realtek wifi adapter running on Quantal:
Network controller: Realtek Semiconductor Co., Ltd. RTL8188CE 802.11b/g/n WiFi Adapter (rev 01)
I can obtain an IP from the router
wlan0 Link encap:Ethernet HWaddr e0:06:e6:c2:d2:e0 inet addr:192.168.0.102 Bcast:192.168.0.255 Mask:255.255.255.0 inet6 addr: fe80::e206:e6ff:fec2:d2e0/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:178844 errors:0 dropped:0 overruns:0 frame:0 TX packets:101517 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:121465876 (121.4 MB) TX bytes:10612848 (10.6 MB)
I can ping other devices:
➜ ~ ping 192.168.0.101 PING 192.168.0.101 (192.168.0.101) 56(84) bytes of data. 64 bytes from 192.168.0.101: icmp_req=1 ttl=64 time=3.84 ms 64 bytes from 192.168.0.101: icmp_req=2 ttl=64 time=1.32 ms
I can not ping the gateway:
➜ ~ ping 192.168.0.1 PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data. From 192.168.0.102 icmp_seq=1 Destination Host Unreachable From 192.168.0.102 icmp_seq=2 Destination Host Unreachable
My resolv.conf is autogenerated with:
➜ ~ cat /etc/resolv.conf
# Dynamic resolv.conf(5) file for glibc resolver(3) generated by resolvconf(8) # DO NOT EDIT THIS FILE BY HAND -- YOUR CHANGES WILL BE OVERWRITTEN nameserver 127.0.1.1 search nc.rr.com
➜ ~ cat /etc/hosts 127.0.0.1 localhost 127.0.1.1 quantal
My routing table:
➜ ~ route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface default 192.168.0.1 0.0.0.0 UG 0 0 0 wlan0 link-local * 255.255.0.0 U 1000 0 0 wlan0 192.168.0.0 * 255.255.255.0 U 9 0 0 wlan0
Lastly, my module info for device:
➜ ~ modinfo rtl8192ce filename: /lib/modules/3.5.0-17-generic/kernel/drivers/net/wireless/rtlwifi/rtl8192ce/rtl8192ce.ko firmware: rtlwifi/rtl8192cfw.bin description: Realtek 8192C/8188C 802.11n PCI wireless license: GPL author: Larry Finger <[email protected]> author: Realtek WlanFAE <[email protected]> author: lizhaoming <[email protected]> srcversion: DD4F3D83A75531AC98862F2 alias: pci:v000010ECd00008176sv*sd*bc*sc*i* alias: pci:v000010ECd00008177sv*sd*bc*sc*i* alias: pci:v000010ECd00008178sv*sd*bc*sc*i* alias: pci:v000010ECd00008191sv*sd*bc*sc*i* depends: rtlwifi,mac80211 vermagic: 3.5.0-17-generic SMP mod_unload modversions parm: swlps:bool parm: swenc:using hardware crypto (default 0 [hardware]) (bool) parm: ips:using no link power save (default 1 is open) (bool) parm: fwlps:using linked fw control power save (default 1 is open) (bool)
Things I've attempted:
Turning off fwlps, ips. Attempted to compile a driver from upstream(realtek.com) and even tried the latest daily mainline kernel for Quantal. Also tried latest compat-wireless and switching out firmware. Tested Windows 7 and verified the card worked. Tested slackware 14, Fedora, Arch and they all exhibit the same issue.
Has anyone seen this before? What really baffles me is that I can not ping the gateway. To verify I can ping the gateway from another system:
λ ~ → ping 192.168.0.1 PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data. 64 bytes from 192.168.0.1: icmp_req=1 ttl=64 time=1.35 ms 64 bytes from 192.168.0.1: icmp_req=2 ttl=64 time=1.22 ms 64 bytes from 192.168.0.1: icmp_req=3 ttl=64 time=5.11 ms
This also doesn't happen outside of my network as I was able to use this laptop at UDS-R which kind of points to a router issue but anything without a Realtek adapter works :\
I dont know if any Realtek developers monitor this site but has anyone run into an issue like this?