Tell me more ×
Ask Ubuntu is a question and answer site for Ubuntu users and developers. It's 100% free, no registration required.
up vote 3 down vote favorite
1

I wanted to try Ubuntu so I was going to partition my hard drive so I restart my computer with my live CD in the disc drive

when it boots it shows the typical booting screen for about ten minutes then the screen goes to text only and says that it can't mount/dev/loop0 first I type

help

then I type

mount /dev/loop0

then it says fstab cannot be found

and I don't know were to go from there

I have seen numerous times that it could be a ram problem

I am not someone who knows much about memory so this is a snippet from my dell inspiron 8500

Memory

Memory module connector two user-accessible SODIMM sockets Memory module capacities 256 MB, 512 MB, and 1024 MB Memory type 266-MHz DDR SDRAM Standard memory 256 MB Maximum memory 2 GB

share|improve this question

1 Answer

up vote 3 down vote accepted

This can happen when you have a bad CD image (or you don't have enough RAM to run the installer), check the answers to these questions and see if they help:

If you don't have enough RAM for the desktop installer try the alternate installer CD.

share|improve this answer
this is actually my second cd I thought I had a bad image so I downloaded another one and burned to another cd – Luke San Antonio Dec 23 '10 at 23:38
it is very possible that I don't have enough RAM I have a very small not-a-lot-of-memory computer – Luke San Antonio Dec 23 '10 at 23:41

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.