Ask Ubuntu is a question and answer site for Ubuntu users and developers. Join them; it only takes a minute:

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

Is there a TUI for fdisk ?

Where can I get it from and how can I use it?

I would like one which is in the ubuntu repos

share|improve this question
up vote 4 down vote accepted

Yes, There is such a tool


It is a curses based partition editor. It is based on fdisk

It is preinstalled on ubuntu, If not just use the following command to install it

sudo apt-get install util-linux

run it using

sudo cfdisk

You will get this screen


Using cfdisk

The user interface

After you have started cfdisk you'll get an interface where the current partition table is listed with the names and some data about each partition, and some command buttons on the bottom of the screen. To change between partitions, use the up and down arrow keys. To change between commands, use the left and right arrow keys.

Deleting a partition To delete an existing partition, highlight it with the up and down keys, select the Delete command with the left and right arrow keys, and press Enter.

Making a new partition

To make a new partition, select the New command with the left and right arrow keys, and press enter. You'll get the choice between a primary and a logical partition. If you want a logical partition, the program will automatically make an extended partition for you. Then you must choose the size of the partition (in MB). If you can't enter a value in MB, return to the main screen with the Esc key, and select MB with the Units command.

Set the type of a partition

To set the type of a partition, for bootable PReP, Linux swap or Linux ext2, highlight the actual partition, and select the Type command. You'll get a list over different types. Press space, and you'll get even more. Find what type you need, and enter the number at the prompt.

Make a partition bootable

To be able to boot from a primary partition, you need to make it bootable. Highlight the actual partition and select the Bootable command.

Write the result to disk and quit

When you are content with the layout of the disk, select the Write command. The partition table will be written to disk. Remember that this will destroy all data on partitions you have deleted or changed. You should therefore be very sure that you want to do this before actually press the Return key.

For more deeper information, see here:

Taken From:

share|improve this answer

Your Answer


By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.