I recently updated the system and now am unable to connect to the Internet via WiFi or cable.
I suppose I should clarify that while it recognizes the connections it does not connect to the web. All other connectivity is fine.
All other devices wired and WiFi within my home are fine and absolutely nothing has changed with my network settings whatsoever.
P.S. I do have the infamous Broadcom card in a Dell inspiron.
I've also booted to all previous Kernels and still nothing.
billy@BillyLaptop:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:1c:23:89:46:5f
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:47 errors:0 dropped:0 overruns:0 frame:0
TX packets:48 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7200 (7.2 KB) TX bytes:8654 (8.6 KB) Interrupt:21
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:2672 errors:0 dropped:0 overruns:0 frame:0
TX packets:2672 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:233285 (233.2 KB) TX bytes:233285 (233.2 KB)
wlan0 Link encap:Ethernet HWaddr 00:1c:26:3a:65:aa
inet addr:192.168.11.5 Bcast:192.168.11.255 Mask:255.255.255.0
inet6 addr: fe80::21c:26ff:fe3a:65aa/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2789 errors:0 dropped:0 overruns:0 frame:0
TX packets:180 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:365198 (365.1 KB) TX bytes:32067 (32.0 KB)
billy@BillyLaptop:~$ route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 192.168.11.1 0.0.0.0 UG 0 0 0 wlan0
192.168.11.0 0.0.0.0 255.255.255.0 U 9 0 0 wlan0
billy@BillyLaptop:~$ nmcli dev list iface wlan0
GENERAL.DEVICE: wlan0
GENERAL.TYPE: 802-11-wireless
GENERAL.VENDOR: Broadcom Corporation
GENERAL.PRODUCT: Wireless 1390 WLAN Mini-Card
GENERAL.DRIVER: b43
GENERAL.DRIVER-VERSION: 3.13.0-32-generic
GENERAL.FIRMWARE-VERSION: N/A
GENERAL.HWADDR: 00:1C:26:3A:65:AA
GENERAL.STATE: 100 (connected)
GENERAL.REASON: 0 (No reason given)
GENERAL.UDI: /sys/devices/pci0000:00/0000:00:05.0/0000:0b:00.0/ssb0:0/net/wlan0 GENERAL.IP-IFACE: wlan0
GENERAL.NM-MANAGED: yes
GENERAL.AUTOCONNECT: yes
GENERAL.FIRMWARE-MISSING: no
GENERAL.CONNECTION: /org/freedesktop/NetworkManager/ActiveConnection/2 CAPABILITIES.CARRIER-DETECT: no
CAPABILITIES.SPEED: 48 Mb/s
CONNECTIONS.AVAILABLE-CONNECTION-PATHS: /org/freedesktop/NetworkManager/Settings/{0}
CONNECTIONS.AVAILABLE-CONNECTIONS[1]: 58555ac2-5665-41c6-98db-633d44173cb7 | HarperBentley
WIFI-PROPERTIES.WEP: yes
WIFI-PROPERTIES.WPA: yes
WIFI-PROPERTIES.WPA2: yes
WIFI-PROPERTIES.TKIP: yes
WIFI-PROPERTIES.CCMP: yes
WIFI-PROPERTIES.AP: yes
WIFI-PROPERTIES.ADHOC: yes AP[1].SSID: 'TG862G12'
AP[1].BSSID: 14:AB:F0:31:D1:10
AP[1].MODE: Infrastructure
AP[1].FREQ: 2462 MHz
AP[1].RATE: 54 MB/s
AP[1].SIGNAL: 50
AP[1].SECURITY: WPA2
AP[1].ACTIVE: no
AP[2].SSID: '2WIRE322'
AP[2].BSSID: B8:E6:25:26:7A:51
AP[2].MODE: Infrastructure
AP[2].FREQ: 2457 MHz
AP[2].RATE: 54 MB/s
AP[2].SIGNAL: 60
AP[2].SECURITY: WPA WPA2
AP[2].ACTIVE: no
AP[3].SSID: 'HarperBentley'
AP[3].BSSID: 00:24:A5:34:98:19
AP[3].MODE: Infrastructure
AP[3].FREQ: 2412 MHz
AP[3].RATE: 54 MB/s
AP[3].SIGNAL: 78
AP[3].SECURITY: WPA WPA2
AP[3].ACTIVE: yes
IP4.ADDRESS[1]: ip = 192.168.11.5/24, gw = 192.168.11.1
IP4.DNS[1]: 192.168.11.1
IP4.DOMAIN[1]: satx.rr.com
DHCP4.OPTION[1]: domain_name = satx.rr.com
DHCP4.OPTION[2]: expiry = 1408997236
DHCP4.OPTION[3]: broadcast_address = 192.168.11.255
DHCP4.OPTION[4]: dhcp_message_type = 5
DHCP4.OPTION[5]: dhcp_lease_time = 172800
DHCP4.OPTION[6]: ip_address = 192.168.11.5
DHCP4.OPTION[7]: routers = 192.168.11.1
DHCP4.OPTION[8]: subnet_mask = 255.255.255.0
DHCP4.OPTION[9]: domain_name_servers = 192.168.11.1
DHCP4.OPTION[10]: network_number = 192.168.11.0
DHCP4.OPTION[11]: dhcp_server_identifier = 192.168.11.1
Thank you immensely for any and all your help.