0

I am dual booting Ubuntu 12.04 and Windows 8. Earlier today, after restarting due to some input issues, I started getting the message upon selecting Ubuntu from GRUB, "errors were found while checking the disk drive for /". I opted to ignore it, and Ubuntu loaded as normal. Upon checking the Disk Utility tool, I see the SMART status "Disk has a few bad sectors". When checking the specific information, I am given a warning for "Current Pending Sector Count". What does this mean? Should I allow an automated attempt to fix the issue? I've had further trouble caused by allowing automated fixes to run before because of conflicts with Windows 8 and UEFI, but I have no idea if there is any association between that and this issue. I can't imagine this is due to physical hard drive damage, as it is very new hardware. Thanks to anyone who can explain it.

4
  • What do you mean "automated attempt"? And how many pending sectors are there?
    – psusi
    Oct 17, 2013 at 18:40
  • On startup, I'm given the option to allow an automated fix, along with the options to ignore and continue or attempt a manual recovery. there is only one pending sector.
    – Sylan
    Oct 17, 2013 at 20:32
  • Yes, fix the filesystem first, then check the smart status.
    – psusi
    Oct 17, 2013 at 22:41
  • After allowing the automated filesystem fix to run on startup, the error no longer shows up upon trying to boot into Ubuntu. However, the smart status remains the same as before. I'm content with not having an error on startup, but should I be concerned of the presence of one bad sector?
    – Sylan
    Oct 18, 2013 at 9:14

3 Answers 3

0

Sometimes sudden power failure can result in one sector being reported as bad because it didn't get completely written. You can run sudo smartctl -t long /dev/sda to ask the drive to test itself. Check the status every once in a while with sudo smartctl -a /dev/sda and when it finds a bad sector, note the sector number, then do:

sudo dd iflag=direct if=/dev/sda count=1 skip=sector of=/dev/null

That should report an IO error, if not then something is wrong and you should not proceed.

sudo dd if=/dev/zero count=1 oflag=direct of=/dev/sda seek=sector

This will try to re-write that sector full of zeros. This should succeed and the SMART pending_sector count should drop by one. If the sector was physically damaged, then the reallocated_count will go up by one. Repeat the process until you have no more pending sectors and if you have no reallocated sectors either, then it was just sudden power loss, and the drive is fine. If you do have reallocated sectors, then then drive may be on its way out and you should replace it.

0

There are several duplicates of this question, such as:

Unfortunately, the answers vary. My own opinion is that, once bad sectors start showing up in a SMART test, the disk has become unreliable. I therefore recommend replacing it ASAP.

0

Following psusi recommendation, I succeeded clearing my "bad sector".

For more details for beginners:

 sudo smartctl -t long /dev/sda
 sudo smartctl -a /dev/sda 

I obtained:

 196 Reallocated_Event_Count 0x0032   200   200   000    Old_age   Always       -     0
 197 Current_Pending_Sector  0x0032   200   200   000    Old_age   Always       -       1

 (...)

 # 1  Extended offline    Completed: read failure       90%     47004         2730908512

 sudo dd iflag=direct if=/dev/sda count=1 skip=2730908512 of=/dev/null

Gave me an error, but:

 sudo dd if=/dev/zero count=1 oflag=direct of=/dev/sda seek=2730908512

Succeeded and

 sudo smartctl -a /dev/sda 

Gave me no more errors:

 196 Reallocated_Event_Count 0x0032   200   200   000    Old_age   Always       -     0
 197 Current_Pending_Sector  0x0032   200   200   000    Old_age   Always       -       0

So, thank you very much psusi for your reply, years later it's still useful :-)

Kind regards,

Txvs

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .